Get Commands - Pioneer PDP-433CMX Technical Manual

5.5.5 GET commands

What are GET commands?
• They are commands used for TXD output of adjustment data and the like from the plasma display's built-in
microcomputer to a personal computer.
• Adjustment data, etc., is output in ASCII code.
(NOTE) Command names are given inside brackets < >.
• Data output format
STX (02hex) Data
(NOTE)
1) GET commands will be invalid if sets have not has not been assigned ID Nos.
2) GET commands will be invalid if a wildcard (*) is used in the ID No. when the command is transmitted.
1) <GPS> (GET POSITION DATA) – SCREEN adjustment data will be output as follows.
Order
1 H.POSITION
2 V.POSITION
3 CLOCK
4 PHASE
5 V.SIZE
(NOTE) If the current input signal is a video signal or digital RGB signal, the adjustment data will be output as
dummy data.
2) <GWB> (GET W/B DATA) – PICTURE and WHITE BALANCE adjustment data will be output as follows.
Order
1 CONTRAST
2 Dummy data
3 BRIGHT
4 Dummy data
5 COLOR
6 Dummy data
7 TINT
8 Dummy data
9 R HIGH
10 Dummy data
11 G HIGH
12 Dummy data
13 B HIGH
14 Dummy data
15 R LOW
16 Dummy data
17 G LOW
18 Dummy data
19 B LOW
20 Dummy data
21 H.ENHANCE (H.SHARP)
22 V.ENHANCE (V.SHARP)
(NOTE) If the current input signal is from a personal computer, the adjustment data will be output as dummy data.
Data ····
Data
Data
RS-232C Adjustment Mode
Data ETX (03hex)
Size Remarks
3byte
3byte
3byte (NOTE)
3byte (NOTE)
3byte
Size Remarks
3byte
3byte
3byte
3byte
3byte (NOTE)
3byte
3byte (NOTE)
3byte
3byte
3byte
3byte
3byte
3byte
3byte
3byte
3byte
3byte
3byte
3byte
3byte
3byte
3byte
183