Pioneer PDP-433CMX Technical Manual page 33

[503CMX/503MXE : 433CMX/433MXE]
4) Arranging and securing cables with speed clamps and bead bands
1
Fasten cables using the supplied speed
clamps.
Remember that speed clamps are not
easily removed, once fastened.
1
1
Organize cables together using the provided
speed clamps.
Insert 1 into an appropriate hole on the rear of the
unit, then snap 2 into the back of 1 to fix the
clamp.
Speed clamps are designed to be difficult to undo
once in place. Please attach carefully.
To attach the speed clamps to the main unit
Connect the speed clamps using the 4 holes marked with
• below, depending on the situation.
To remove speed clamps
Using pliers, twist the clamp 90° and pull it outward.
In some cases the clamp may have deteriorated over
time and may be damaged when removed.
2
* As viewed from the rear of the display.
2
2
Bunch separated cables together and
secure them with the provided bead bands.
Note
Cables can be routed to the right or left.
Installation Procedures
Secure cables with the supplied bead bands.
33