Setting Power Management And Auto Power On/Off - Pioneer PDP-433CMX Technical Manual

Plasma display monitor
Hide thumbs Also See for PDP-433CMX:
Table of Contents

Advertisement

2) Setting POWER MANAGEMENT and AUTO POWER ON/OFF

To save electricity, this function automatically shifts the device into power-saving mode when no picture (sync)
signal is detected.
• If not using this power-saving function
→ select OFF.
• To enter power standby if no input signal is detected after 8 min
→ select AUTO POWER OFF: ON.
• To switch between routine operating status and power-saving status, in accordance with the presence of signals
→ Select POWER MANAGEMENT: ON.
Set-able condition
Factory preset
1 Select SET UP.
Screen 1
MAIN MENU
PICTURE
SCREEN
I N P UT
L A
B
E
L
POWE R
M NA GEME
A
C L AMP
P S I T I O N
O
S E T T I N
G
SELECT
SET
(NOTE)
• To restore routine operating status from power standby status, press the POWER button on the remote control or
main unití-s operation panel.
• To restore routine operating status from power-saving status, either use a personal computer or press the INPUT
button on the remote control or main units operation panel.
However, when there is G ON SYNC or composite SYNC input, it will not be possible to restore routine operating
status via personal computer alone. The INPUT button will need to be pressed after the personal computer has
been operated appropriately.
• Power consumption in power standby mode will be 1W.
• Power consumption in power-saving mode will be around 1W for INPUT 1 and around 50W for INPUT 5.
: POWER MANAGEMENT: INPUT 1 (personal computer signal), INPUT5
when equipped with PDA-5002)
AUTO POWER OFF; other than the above
: OFF
INPUT1
SET UP
OPTION
:
I N P UT 1
:
NT
OF F
: A U T O
: V G A
ENTER
EXIT
MENU
2 Move the cursor to POWER MANAGEMENT
(AUTO POWER OFF) and use the SET button to
change the setting.
Setting will change between OFF and ON each
time the SET button is pressed.
Screen 2
MAIN MENU
PICTURE
SCREEN
I N P UT
L A
B
E
L
POWE R
M NA GEME
A
C L AMP
P S I T I O N
O
S E T T I N
G
SELECT
CHANGE
SET
Menu Mode
#
(applies only
INPUT1
SET UP
OPTION
:
I N P UT 1
:
NT
OF F
: A U T O
: V G A
EXIT
MENU
137

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pdp-503cmxPdp-503mxePdp-433mxe

Table of Contents