Oven Light Bulb Replacement; In Case Of Power Failure; Leveling The Grates - DCS 30 inch Care And Use Manual

CARE and MAINTENANCE
cleaners cause darkening and discoloration. Test the cleaner
on a small part of the rack and check for any discoloration
before cleaning the entire rack. Apply a generous coating.
Allow to stand for 15 to 20 minutes. Rinse thoroughly and
dry. After being cleaned, if the racks do not slide easily,
pour a small amount of cooking oil on a paper towel and
rub it lightly over the side rails.
FRAME, SIDES, DOOR EXTERIOR,
HEAT DEFLECTOR
These parts are made of stainless steel, follow the directions
for the Back Panel and Shelf. Take care when cleaning the
door top, and do not let water or cleaners run down the
vents. If water or cleaners spill into the vents, they may
streak the glass inside the door.
DOOR GASKET
Use a general kitchen spray cleaner, such as Formula 409®
or Fantastik®. Spray it on and blot dry with a cloth. Do
not rub. Do not remove or damage the mesh.

OVEN LIGHT BULB REPLACEMENT

For oven light bulb replacement use only a 40 watt, 120
volt appliance light bulb. These are available in supermar-
kets. DO NOT use a standard light bulb in any oven, the
heat will break it.
To Replace the Light Bulb
1. Be sure the oven light bulb switch is in the off position
The bottom of the switch is pressed in. Let the cover
and the bulb cool completely.
2. Remove the light cover. Turn the cover to the left
(counterclockwise) to unscrew it.
3. Remove the burnt out bulb. Replace it with a 40 watt
appliance light bulb only.
4. Replace cover. Turn circuit breaker back on, if turned
off. (See Caution).
CAUTION: Be sure the Oven light switch is in the OFF
position and the cover is cool. If the bulb comes loose
from the base, turn off the power to the oven at the circuit
breaker panel, before attempting to remove the bulb base
from the socket.
POWER FAILURE
The broiler, oven, grill or griddle burners cannot be turned
on during a power failure. To light the open top burners,
turn the control knob to "LITE", hold a lighted match to
the port ring. After the flame is burning all the way around
the burner , adjust the flame. It is necessary to light each
burner separately, each time you want to use it.

LEVELING THE GRATES

Each individual burner grate comes equipped with (3)
three leveling screws which can be adjusted for grate align-
ment. Alignment may be necessary to compensate for the
appliances being out of level.
BEFORE YOU CALL FOR SERVICE
• Is the circuit breaker tripped or the fuse blown?
• Is there a power outage in the area?
IF THE COOKTOP BURNERS DO NOT
LIGHT
• Is the two piece burner put together correctly?
• Is the port ring aligned correctly?
• Is the manual shut-off valve open? This is usually
located where the gas comes out of the wall.
SERVICE INFORMATION
Copy the information below from the data rating plate.
Keep your invoice for warranty validation.
Model Number
Serial Number
Date of Purchase
28