Basic Procedures - Panasonic AG-HPX370 Operating Instructions Manual

Basic Procedures

This section describes the basic procedure for shooting
and recording.
Before you embark on a shoot, pre-inspect your system to
ensure that it works properly.
For directions on inspecting your memory card camera-
recorder, see [Inspections Before Shooting] (page 157).
Battery Set-up to P2 card Insertion
1
 Insertachargedbattery.
2
 TurnthePOWERswitchtoONtocheckthe
batteryremaininglevelintheviewfinder.
• When battery capacity is low, replace it with a fully
charged battery.
 NOTE
When low battery capacity is indicated after replacing
a battery with a fully charged battery, check battery
installation.
For details, refer to [BATTERY SETUP screen] (page 144).
3
 InsertaPcard,checkthatthePCARD
ACCESSLEDlightsorangeorgreenbefore
closingtheslotcover.
• When more than one P2 card slot contains a P2
card, the card in the slot with the lowest number
is used first. However, regardless of slot number,
a P2 card inserted later will not be accessed until
the other cards have been used.
Example:
If the two slots contain P2 cards, the cards are
used in order of slot numbers 12. However, if
the P2 card in Slot 1 is removed and then re-
inserted, the cards will be used in the following
order: 21.
1
2
Note that the recording order is retained even if the power
is turned off. When the power is next turned on, the last
card written before powering-down will be the target card.
5