Warning And Error Display For Thumbnail Operation And Usb Host Mode - Panasonic AG-HPX370 Operating Instructions Manual

Warning and Error Display for Thumbnail Operation and USB HOST MODE

Item Message
CANNOT ACCESS!
CANNOT CHANGE!
CANNOT COPY!
CANNOT DELETE !
CANNOT FORMAT!
CANNOT
RECONNECT!
CANNOT REPAIR!
CANNOT REPAIR IN
SELECTION!
CARD FULL!
INVALID VALUE!
LACK OF REC
CAPACITY!
MISSING CLIP!
Thumbnails
NO CARD!
NO COPY TO SAME
CARD!
NO FILE!
NO SD CARD!
SAME CLIP IS
SELECTED!
TOO MANY CLIPS!
UNKNOWN
CONTENTS FORMAT!
UNKNOWN DATA!
USER CLIP NAME
MODIFIED!
WRITE PROTECTED!
CANNOT CHANGE!
Soft
keyboard CANNOT SET! INVALID
VALUE!
Description
Data cannot be accessed because it is
corrupted or for other reasons.
Any thumbnails that cannot be produced
on the AVC-Intra 100 or AVC-Intra 50 and
displayed in gray cannot be changed at the
text memo position.
Images cannot be copied.
P2 card contains contents version
mismatches or bad clips.
P2 card problem prevents formatting.
A clip that does not span multiple P2 cards
cannot be reconnected.
Data cannot be repaired since content that
cannot be repaired is selected.
Some of the selected clip could not be
repaired.
The P2 or SD card is full.
Entered data was invalid.
There is not enough recording capacity left
on the card.
A shot mark will be added to the clips
recorded on multiple P2 cards when all P2
cards are not inserted yet.
No P2 or SD card is inserted.
A clip cannot be copied to the card storing
the original clip.
The designated file is not found.
No SD card is inserted.
The clip cannot be copied because a clip
that has already been copied and the original
clip have been selected.
Too many clips are selected.
P2 card contains contents version
mismatches or corrupted content.
The metadata character code is invalid.
Characters in the clip name had to be
deleted in adding the counter value.
The P2 or SD card is write protected.
[PERSON] will be entered while the text
memo is not available.
The entered value is incorrect.
Measure
Restore media and clips to normal state
before access.
Set SYSTEM MODE according to the clips.
Check the conditions for copying.
Match devices and contents versions, and
repair bad clips.
Check P2 card.
Check selected content.
Check selected content.
—
Insert media with sufficient capacity.
Enter data in a valid range.
Insert a card with sufficient recording
capacity.
Insert all P2 cards with recorded clips,
and confirm that the ! incomplete clip
indicators disappear, and then add shot
marks.
Insert compatible media.
Copy the selected clip to a card that does
not contain the original clip.
Check the file.
Insert an SD card.
Confirm the selected clip and release
either the source clip or the destination
clip and then execute the copy operation.
Reduce the number of selected clips.
• Match devices and contents versions.
• If corrupted clips exist (including
corrupted clips that are located on the
copy destination), repair the corrupted
clips or delete them.
Use UTF-8 for the metadata character
code. Use the viewer to enter correct
characters.
The user clip name plus the counter
value can only contain up to 100
bytes. Characters in the clip name are
automatically deleted when the total
exceeds 100bytes.
Insert write-enabled media.
Enter [TEXT] before entering [PERSON].
Change the value.
(Continued on the next page)
16