Panasonic AG-HPX370 Operating Instructions Manual page 139

Item
ONE SHOT TIME Sets the duration for one-shot recording.
1frm, 2frm, 4frm, 8frm, 16frm, 1s
For details, refer to [One-shot recording (ONE SHOT
REC)] (page 43).
INTERVAL TIME Sets the time interval of interval recording.
2frm, 4frm, 8frm, 16frm, 1s, 2s, 5s, 10s, 30s, 1min,
5min, 10min
For details, refer to [Interval recording (INTERVAL
REC)] (page 43).
START DELAY This delays the start of interval and one-shot recording
by about 1 second.
ON, OFF
PREREC MODE Sets PRE REC.
ON, OFF
For details, refer to [Pre-recording (PRE REC)]
(page 42).
TC MODE Sets count correction when using the internal time
code generator.
DF: Drop frame time code
NDF: Non drop frame time code
For details, refer to [Setting the Time Code] (page 69).
UB MODE Sets the data recorded in the camera user bits.
USER, TIME, DATE, EXT, TCG, FRM.RATE
For details, refer to [Setting user bits] (page 67).
ONE CLIP REC Sets one-clip recording mode.
ON, OFF
For details, refer to [One-clip recording] (page 44).
START TEXT MEMO Sets whether to automatically add a text memo at the
recording start position each time you start recording.
ON, OFF
Setting Notes
• Available only when REC FUNCTION
is set to ONE SHOT.
• Available only when REC FUNCTION
is set to INTERVAL.
• Available only when REC FUNCTION
is set to INTERVAL or ONE SHOT.
• Not available in the following
conditions.
- When REC SIGNAL is set to 1394
- When SYSTEM MODE is set to 720-
59.94P (720-50P) and VFR is set to
ON.
- When REC FORMAT is set to native
recording.
- When SYSTEM MODE is set to 1080-
59.94i or 480-59.94i; and CAMERA
MODE is set to 24P or 24PA.
- When REC FUNCTION is set to
something other than NORMAL.
• This item is not displayed when
SYSTEM MODE is set to 50 Hz.
• Not available when operating at 24P,
24PA and 24PN is set to ON. Then
NDF is used at all times.
• Not available in the following
conditions.
- When REC FUNCTION is set to
something other than NORMAL.
- When REC SIGNAL is set to 1394.
- When VFR is set to ON
• Not available when REC FUNCTION is
set to something other than NORMAL.
• The text memo that is added when this
is set to ON indicates the recording
start position.
For details on recording the text memo
as text information, refer to [Setting of
Clip Meta Data] (page 119).
____ indicates the factory setting
19