Subscribe to Our Youtube Channel
Related Manuals for Antunes GST-1H
Summary of Contents for Antunes GST-1H
- Page 1 ® Flatbread Toaster Model GST-1H Owner’s Manual Manufacturing Numbers: 9210973 www.antunes.com P/N 1012033 Rev E 04/20...
-
Page 2: Table Of Contents
Limited Warranty ......20 IMPORTANT Antunes reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment. -
Page 3: Important Safety Information
This equipment should be manufacturer or its service agent serviced by qualified personnel or a similarly qualified person only. Contact Antunes Technical in order to avoid a hazard. Service for adjustment or repair. Do not modify the power supply Do not block or cover any cord plug. -
Page 4: Specifications
Specifications Dimensions 23.4 [593.4] [747.6] 52° [228.6] 17.25 [438.0] [201.9] [706.4] Electrical Model & Plug Volts Watts Hertz Mfg. No. Description L6-30P 30 Amp., GST-1H 4600 250 Volt, 9210973 Straight Twist Lock P/N 1012033 Rev E 04/20 ®... -
Page 5: Installation
Allow to air dry. is the darkest setting. Figure 1. Flatbread Toaster (GST-1H) Wipe the entire exterior of the To save the light/dark value, wait 5 sec- unit with a clean sanitizer soaked onds until the screen displays “USE”. -
Page 6: User Mode
5 seconds. After 5 seconds, continuous resetting, contact if off (meaning 0°F) it may be the display will show the actual Antunes Technical Service. incremented from 0°F to 150° temperature of the bottom Platen. Press the LIGHTER button to NOTE: The “USE”... -
Page 7: Daily Cleaning
Belts completely. Failure cleaners are required for to properly clean the Belts cleaning and have been will shorten the life of the validated by Antunes to be Belts and result in poor the most effective. The use performance. of alternative supplies and... - Page 8 Installing Belts LOWER THIS BRACKET Follow the steps for Removing LOWER THIS BRACKET Belts. Wipe both sides of the new Belts with a clean, sanitized towel sprayed with an approved sanitizer and allow to air dry. Slide the new bottom belt over the bottom rollers (Figure 6).
- Page 9 BELT IS TORN AND FOLDED. REPLACE BELT. Figure 10. Example of Damaged Belt Figure 9. Example of Damaged Belt BELT IS TORN IN THE CENTER. BELT IS MISSING SNAPS REPLACE BELT. AND IS DAMAGED. REPLACE BELT. Figure 11. Example of Damaged Belt Figure 12.
-
Page 10: Troubleshooting
Allow the unit to warm up for 30 minutes and then recheck. If the Control Display still flashes Er13, contact your point temperature. Control Display flashes error maintenance person or Antunes Technical Service for service. continuously. Product not Failed Top Platen Thermocouple. Contact your maintenance person or Antunes Technical toasting properly. - Page 11 Clean fans as described in the Cooling Fan is dirty and needs to be cleaned. Maintenance section of this manual. If problem persists, contact your maintenance person or Antunes Technical Service for service. Control Display flashes HL Hi-Limit Control is tripped.
-
Page 12: Replacement Parts
Replacement Parts ITEM PART NO. DESCRIPTION ITEM PART NO. DESCRIPTION 0013093 Brkt Assy Top 0701006 Wire Set, Transformer 0013094 Brkt Assy Bottom 0701007 Wire Set, Main 0013095 Bearing Brkt Assy 0701008 Wire Set, Platen 7001406 Assy, Drive Chain Tensioner 0701009 Wire Set, Power 0013111 Assy, Drive Chain Tensioner... -
Page 13: Exploded Diagram #1
Exploded Diagram #1 P/N 1012033 Rev E 04/20 ®... -
Page 14: Exploded Diagram #2
Exploded Diagram #2 7001465 P/N 1012033 Rev E 04/20 ®... -
Page 15: Exploded Diagram #3
Exploded Diagram #3 100a Note: Axial Fan #7001472 Must Be Mounted with Arrows Pointed Inward P/N 1012033 Rev E 04/20 ®... -
Page 16: Exploded Diagram #4
Exploded Diagram #4 P/N 1012033 Rev E 04/20 ®... -
Page 17: Exploded Diagram #5
Exploded Diagram #5 P/N 1012033 Rev E 04/20 ®... -
Page 18: Wiring Diagram
Wiring Diagram P/N 1012033 Rev E 04/20 ®... -
Page 19: Notes
NOTES P/N 1012033 Rev E 04/20 ®... -
Page 20: Limited Warranty
Travel Time & Mileage in excess of 2 hours (100 miles/160 km) round trip from the nearest authorized service agency. Antunes reserves the right to make changes in design or add any improvements on any product. The right is always re- served to modify equipment because of factors beyond our control and government regulations.
Need help?
Do you have a question about the GST-1H and is the answer not in the manual?
Questions and answers