Page 1
® Flatbread Toaster Model GST-1H Manufacturing Numbers: 9210970, 9210971, and 9210972 P/N 1011446 Rev. I 12/18 www.antunes.com...
Page 2
If you experience any problems with the Information ranty in this manual. installation or operation of your unit, con- Service/Technical tact Antunes Technical Service at +1-877- If the unit arrives damaged, contact the Assistance 392-7854 (toll free). carrier immediately and file a damage claim Important Safety with them.
Page 3
This equipment should be serviced If the supply cord is damaged, it by qualified personnel only. Contact must be replaced by the manu- Antunes Technical Service for ad- facturer or its service agent or justment or repair. a similarly qualified person Do not block or cover any openings in order to avoid a hazard.
Page 5
Wipe the entire exterior of the unit Figure 1. - Flatbread Toaster (GST-1H) with a clean sanitizer soaked towel. To save the light/dark value, wait 5 seconds Allow to air dry.
The unit will exit User Mode after cool. Then turn the toaster on. If the error 5 seconds of keypad inactivity. A Hi-Limit Control turns off electrical power repeats, contact Antunes Technical Service to the heaters and control circuits and MANAGER MODE for assistance.
NOTE: Any debris stuck on the roller/ ing and have been validated by unit with a clean, sanitizer-soaked Antunes to be the most ef- cover plates can damage the towel and allow to air dry. belts. fective. The use of alternative supplies and chemicals may not Reinstall all accessories (Figure 3).
Page 8
Installing Belts LOWER THIS CLIP BRACKET Follow the steps for Removing Belts. LOWER THIS BRACKET Wipe both sides of the new Belts with a clean, sanitized towel sprayed with an approved sanitizer CLIP and allow to air dry. Slide the new bottom belt over the bottom rollers (Figure 6).
Page 9
BELT IS TORN AND FOLDED. REPLACE BELT. Figure 10. Example of Damaged Belt Figure 9. Example of Damaged Belt BELT IS TORN IN THE CENTER. BELT IS MISSING SNAPS REPLACE BELT. AND IS DAMAGED. REPLACE BELT. Figure 11. Example of Damaged Belt Figure 12.
Control Display still flashes PLt, contact your maintenance person properly. or Antunes Technical Service for service. Failed Platen Thermocouple. Contact your maintenance person or Antunes Technical Service for service. Failed Control Board Control Display flashes Er 10 Control Compartment ambient temperature is Verify side vents on toaster are unblocked and not near other continuously.
Page 11
Replace Belts Motor Drive Chain is detached from sprockets. Reinstall the Drive Chain. Failed Drive Motor. Contact your maintenance person or Antunes Technical Service for service. Belts are ripped or torn. Rollers or Heater Cover Plates are dirty and need Clean Rollers and Heater Cover Plates as outlined in the Mainte- to be cleaned.
Antunes reserves the right to make changes in design or add any improvements on any product. The right is always reserved to modify equipment because of factors beyond our control and government regulations. Changes to up- date equipment do not constitute a warranty charge.
Need help?
Do you have a question about the GST-1H and is the answer not in the manual?
Questions and answers