Manufacturing Number Wiring Diagram Replacement PArts Limited Warranty IMPORTANT A.J. Antunes & Co. reserves the right to change specifications and product de- sign without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
IMPORTANT SAFETY WARNINGS INFORMATION Be advised of the following warnings when operating and performing mainte- Use the following guidelines for safe op- nance on this unit. eration of the unit. If the supply cord is damaged, it Read all instructions be- must be replaced by the manu- fore using equipment.
Figure 1. GST-2V Toaster • Do not block or cover any open- Figure 2. - GST-2V Control Panel ings on the unit. • Do not immerse the power cord BUN FEEDER or plug in water.
Pass Through Time. Adjust the Motor Speed Setpoint by service +1 (877) 392-7854 pressing the LIGHTER or DARKER buttons change the pass through Figure 4. - GST-2V Control Panel time in 0.5 second increments. P/N 1011443 Rev. C 08/17...
DAILY CLEANING Wash, rinse, and sanitize the bun BUN FEEDER feeder and top cover in the three- Clean the Toaster and Belt Wraps compartment sink. REAR TOP COVER Wash, rinse, and sanitize the front Press the Power button to turn CONVEYOR and rear conveyor covers in the COVER...
Page 8
BELT IS TORN AND FOLDED. REPLACE BELT. Figure 7. Example of Damaged Belt Figure 9. Example of Damaged Belt BELT IS MISSING SNAPS AND IS DAMAGED. REPLACE BELT. Figure 8. Example of Damaged Belt P/N 1011443 Rev. C 08/17...
QUARTERLY CLEANING Install Belt Wraps BUN FEEDER If you are installing the existing belt TOP COVER Remove Belt Wraps and Clean REAR wraps, inspect the belts. Replace CONVEYOR Rollers belt wraps if worn or damaged. If COVER the belt wraps are in good condi- Press the Power button to turn tion put them back on the toaster.
Clean Cooling Fan and Electrical Housing Press the Power button to turn CLEAN INSIDE AND OUTSIDE the unit off. The unit enters a cool OF FAN down mode and the belts continue to turn. The toaster automatically REMOVE SCREW shuts down when complete. Wait for the unit to shut down.
Control Display still flashes PLt, contact your maintenance person continuously. Buns not toasting properly. or Antunes Technical Service for service. Failed Platen Thermocouple. Contact your maintenance person or Antunes Technical Service for service. Failed Control Board Control Display flashes Er 10 Control Compartment ambient temperature is Verify side vents on toaster are unblocked and not near other continuously.
Replace Belts Motor Drive Chain is detached from sprockets. Reinstall the Drive Chain. Failed Drive Motor. Contact your maintenance person or Antunes Technical Service for service. Belts are ripped or torn. Rollers or Heater Cover Plates are dirty and need Clean Rollers and Heater Cover Plates as outlined in the Mainte- to be cleaned.
Page 15
ITEM PART ITEM PART ITEM PART DESCRIPTION QTY. DESCRIPTION QTY. DESCRIPTION QTY. NUMBER NUMBER NUMBER 2150380 DRIVE CHAIN 0013024 PLATEN ASSY 0507703 BEARING RETAINER 2150384 BEARING ASSY, HIGH TEMP 1 1/8" OD 0013363 ADJUSTABLE FRAME ASSEMBLY 0507723 LOCK BAR X 1/2" ID 0013368 CONTACTOR MOUNT ASSY 0507763...
Travel Time & Mileage in excess of 2 hours (100 miles/160 km) round trip from the nearest authorized service agency. Antunes reserves the right to make changes in design or add any improvements on any product. The right is always re- served to modify equipment because of factors beyond our control and government regulations.
Need help?
Do you have a question about the GST-2V and is the answer not in the manual?
Questions and answers