Analog Devices EVAL-LT7184S-AZ User Manual page 7

EVAL-LT7184S-AZ
Evaluation Board User Guide
7. Then, click the W (PC to RAM) icon to write the register values to the LT7184S. After finishing this step, the output
voltage changes to 1.5V.
8. If the write is successful, the following message will appear.
9. To save the changes to NVM in the toolbar, click the RAM to NVM button.
10. Save the evaluation board configuration to a (*.proj) file. Click the Save icon and save the file with a new name.
analog.com Rev 0 7 of 14