Installation Instructions - Assa Abloy Corbin Russwin CLX3300 Series Installation Instructions Manual

CLX3300 Series with VSL Indicator Trim

Installation Instructions

Install Inside Components
7
1. Remove rose from inside spring housing assembly.
2. Align and insert inside spring housing onto the installed
lockbody.
3. Install screws to tighten the lock to the door.
4. Orient dimples on the side of the rose horizontally at 3 and
9 o'clock position in line with the openings on the spring
housing assembly.
5. Install rose onto the inside spring housing assembly.
6. If indicator trim, go to "Install Button Arm for Indicator
Trim" below. If standard lever trim, continue with steps
7 and 8 to complete installation.
7. For button functions, verify button is in-line with shank
when the lock is in the unlocked position. Adjust the but-
ton, if necessary, by pressing the plunger and moving it in
or out. (See Figure 4.)
8. Install inside lever.
Button in-line with shank indicates correct position based upon door
thickness. If the button needs to be adjusted, position it by depressing the
plunger, moving it in or out as needed.
Install Button Arm for Indicator Trim
8
(RH/RHR installation shown)
The inside assembly with indicator trim must have the button arm (See Figure 5.) attached to the button before the lever is
installed. The button arm will always be installed on the hinge side of the lockbody assembly.
1. Verify the round end of the button arm set screw is pointing towards the door.
2. Snap the button arm into the groove on the button. It will fit securely (See Figure 5).
3. Round end of button arm should align with shank marking in the unlocked state (See Figure 6). Button arm is pre-set
at factory. If necessary, use Allen wrench to adjust set screw to align with the shank marking. (See next page for icon
alignment).
4. Install the inside indicator lever. See next page.
Figure 5
Button Arm
Note: Insert button arm into groove.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com •www.corbinrusswin.com
Copyright © 2024, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Shank
Figure 6
Button Arm
Button Arm
Rose Dimple
Shank
Plunger
Button
Shank
Marking
3
Figure 4
FM809 07/24