Assa Abloy Corbin Russwin CLX3300 Series Installation Instructions Manual

Installation Instructions
Installation Instructions
CLX3300 Series with VSL Indicator Trim
Tools Required
1
• 5/32" drill bit
• #2 Phillips screwdriver
Product Components
2
2
9
7
18
8
13
14
Door Preparation
3
1. Use template FM567 to mark the door (Figure 1).
2. Drill the door according to the template.
3. Verify the dimensions (Figure 2).
4. Install the strike (Figure 3).
Template
Backset must
match latch
Desired
he ight
above
DOOR
floor
FRAME
Figure 1
IMPORTANT
• The accuracy of door preparation is critical for proper functioning and security of this lever handle lock. Misalignment can
cause premature wear and a lessening of security.
• Verify backset before marking and drilling door.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com • www.corbinrusswin.com
Copyright © 2024, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved.
Reproduction in whole or in part without the express written permission of ASSA ABLOY Access
and Egress Hardware Group, Inc. is prohibited.
• 11/32" drill bit
• 5/64" Allen wrench
15
6
17
5
16
10
11
3
12
1" (25mm)
hole
2-1/4"
(57mm)
Door bevel
1-1/8"
(29mm)
Figure 2
• 1/8" drill bit
• Lever Removal Tool
15
1
4
11/32" (8mm) hole
2-3/4"
(70 mm)
2-1/8"
(54mm)
hole
5/32" (4mm)
Fig. Description
1 Inside indicator lever assembly
2 Outside indicator lever assembly
3 Inside spring housing assembly
4 Screws- through-bolt (2) #10-32
x 1-1/4"
5 Lockbody assembly with rose liner
6 Outside spring housing assembly
7 Cylinder spacer
8 Cylinder
9 Key
10 Latch
11 Screws- latch (2) #8-32 x 3/4"
12 Screws-strike (2) #12-24 x 1"
13 Strike
14 Strike Box (Optional)
15 Rose/Scalp (2)
16 Button Arm
17 Shank Insert
18 Lever removal tool
Strike Box
Attaching Screws
#12 -24 x 1"
FM809 07/24
Strike Box
Attaching Screws
#8 -32 x 3/4"
Figure 3