Assa Abloy Corbin Russwin CLX3300 Series Installation Instructions Manual page 4

CLX3300 Series with VSL Indicator Trim
Installation Instructions
Install Inside Indicator Lever
9
1. Rotate the cone inside the lever clockwise so it
aligns to fit over the button arm.
2. Push lever on and snap into place.
Icon Alignment
Button Arm
Cone
NOTE: The adjustment below is only for the inside lever assembly. No adjustment is required on the outside lever assembly,
because it is preset at the factory for door thickness.
If the icons are not entirely visible after installation, see Figure 6 on page 3 to verify the button arm is aligned with the shank
marking. If necessary, adjust the screw set by turning either clockwise or counterclockwise with a 5/64" Allen wrench as shown
below.
If the icon is shifted to the left, use the wrench to make a 1/2 turn counterclockwise to adjust.
If the icon is shifted to the right, use the wrench to make a 1/2 turn clockwise to adjust.
For each adjustment made on the set screw, reinstall to verify the alignment of the icons. Repeat steps as needed.
FM809 07/24
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com •www.corbinrusswin.com
Copyright © 2024, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in
4
part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.