Marantz NR1601 User Manual page 12

ENGLISH ENGLISH DEUTSCH DEUTSCH
Set up speakers (Audyssey ® Auto Setup)
Preparation
4
Connect the setup microphone to the
SETUP MIC jack of this unit.
When the setup microphone is
connected, the following screen is
displayed.
3-1.Audyssey Auto Setup
MultEQ
Please place microphone
at ear height at
main listening position.
F.Height : Measure
Front Sp. : A
Amp Assign: Normal
Start
Cancel
[ENT]:Select [RTN]:Back
The setting method for 7.1-channel playback using
the surround back speakers is described here.
For the method of setting up speakers other than
the 7.1-channel system, select "Amp Assign"
and perform steps 3 and 4 of "Set up speakers"
(vpage 33).
5
Use to select "Start" and then
ui
ENTER
press .
When measuring begins, a test tone is
output from each speaker.
• Measurement requires several minutes.
If "Cancel" is selected
"Cancel Auto Setup?" is displayed on the TV
screen. If "Yes" is selected, "Audyssey Auto
Setup" closes.
8
Remote control operation
buttons
FRANÇAIS FRANÇAIS ITALIANO ITALIANO ESPAÑOL ESPAÑOL
Step 1
Speaker Detection
• In step 1, you will perform measurements at the main listening position.
• This step automatically checks the speaker configuration and speaker size, and calculates the channel
level, distance, and crossover frequency. It also corrects distortion in the listening area.
6
The detected speakers are displayed.
Step1:Speaker Detection
MultEQ
Front Sp. :Yes
Center Sp. :Yes
Subwoofer :Yes
Surround Sp. :Yes
S.Back Sp. :Yes
Next
Retry
[ENT]:Next
NOTE
If a connected speaker is not displayed, the
speaker may not be connected correctly. Check
the speaker connection.
7
Use to select "Next" and then
ui
ENTER
press .
Move the cursor
(Up/Down/Left/Right)
NEDERLANDS NEDERLANDS SVENSKA SVENSKA
NOTE
If "Caution" is displayed:
Go to "Error messages" (vpage 10), check
any related items, and perform the necessary
procedures.
If the problem is resolved, return and restart
"Audyssey Auto Setup".
When performing Audyssey Auto
Setup over again
Press ui to select "Retry", and then press
ENTER
.
When measuring has stopped
ENTER
Press ui to select "Cancel", then press
ENTER
o p
Press to select "Yes", then press
Setting up the speakers again
Repeat the operation from step 4 of Preparation
Confirm the setting
Step 2
Measurement
• In step 2, you will perform measurements at
multiple positions (two to six positions) other than
the main listening position.
• You can achieve a more effective correction of
distortion within the listening area by performing
measurements at multiple positions.
8
Move the setup microphone to
position 2, use to select "Next",
ui
ENTER
and then press .
The measurement of the second position
starts. Measurements can be made in up to
six positions.
Step2:Measurement
MultEQ
Please place microphone
at ear height at
2nd listening position.
Next
.
Calculate
Cancel
.
[ENT]:Next
.
If you want to omit measurements from the next
position onward, select "Calculate".
(Go to Step 3 Calculating )
9
Repeat step 8, measuring positions 3
to 6.
When measurement of position 6 is
completed, a "All the measurements were
finished." message is displayed.
Step2:Measurement
MultEQ
All the measurements
were finished.
Calculate
Retry
Cancel
[ENT]:Calculate
Return to previous menu