Marantz NR1601 User Manual page 10

ENGLISH ENGLISH DEUTSCH DEUTSCH
3
Turn on power
1
Turn on the TV and subwoofer
power.
Power on
2
Change the TV input to the input of
this unit.
3
ON
Press to turn on power to the unit.
The power indicator switches off, and power
is supplied to the unit.
Power on
Power on
The "Simple version" section provides the speaker installation, connection, and setup methods for the 7.1-channel system with surround back
6
speakers. For the installing, connecting, and setup methods of speakers other than the 7.1-channel system (with surround back speakers), see page 30.
FRANÇAIS FRANÇAIS ITALIANO ITALIANO ESPAÑOL ESPAÑOL
1 2
NEDERLANDS NEDERLANDS SVENSKA SVENSKA
4
Set up speakers
3 4 5
(Audyssey ® Auto Setup)
The acoustic characteristics of the connected speakers and listening room are
measured and the optimum settings are made automatically. This is called
"Audyssey Auto Setup".
To perform measurement, place the setup microphone in multiple locations all
around the listening area. For best results, we recommend you measure in six
positions, as shown in the illustration (up to six positions).
• When performing Audyssey Auto Setup, MultEQ ® /Dynamic EQ ® /Dynamic
Volume ® functions become active (vpage 46, 47).
• To set up the speakers manually, use "Speaker Setup" (vpage 49) on the menu.
NOTE
• Make the room as quiet as possible. Background noise can disrupt the room measurements. Close
windows, silence cell phones, televisions, radios, air conditioners, fluorescent lights, home appliances,
light dimmers, or other devices as measurements may be affected by these sounds.
• Cell phones should be placed away from all audio electronics during the measurement process as Radio
Frequency Interference (RFI) may cause measurement disruptions (even if the cell phone is not in use).
• Do not unplug the setup microphone from the main unit until Audyssey Auto Setup is completed.
• Do not stand between the speakers and setup microphone or allow obstacles in the path while the
measurements are being made. This will cause inaccurate readings.
• Loud test sounds may be played during Audyssey Auto setup. This is part of
normal operation. If there is background noise in room, these test signals will
increase in volume.
VOLUME + –
• Operating during the measurements will cancel the measurements.
• Measurement cannot be performed when headphones are connected.
1 2 3 4 5