Set Up Speakers - Marantz NR1601 User Manual

Set up speakers

This section provides the setup methods of speaker systems other than the 7.1-channel system (with surround back speakers).
For the setup methods of the 7.1-channel system with surround back speakers, see "Set up speakers (Audyssey® Auto Setup)" (vpage 6) of "Simple version".
First install and connect the speakers to this unit.
1
Set up
the remote control unit
n Set up the operation mode
Press AMP to set the remote control
unit to amplifier operation mode.
Press AMP
Remote control operation
buttons
SVENSKA SVENSKA NEDERLANDS NEDERLANDS
2
Connect the setup microphone.
When the setup microphone is
connected, the following screen is
displayed.
3-1.Audyssey Auto Setup
MultEQ
Please place microphone
at ear height at
main listening position.
F.Height : Measure
Front Sp. : A
Amp Assign: Normal
Start
Cancel
[ENT]:Select [RTN]:Back
3
Set up "Amp Assign"
Use to select "Amp Assign".
ui
3-1.Audyssey Auto Setup
MultEQ
Please place microphone
at ear height at
main listening position.
F.Height : Measure
Front Sp. : A
Amp Assign: Normal
Start
Cancel
[RTN]:Back
Move the cursor
(Up/Down/Left/Right)
ESPAÑOL ESPAÑOL ITALIANO ITALIANO
4
Use o p to select the configuration
of the connected speakers.
Set when using 9.1-channel
Normal
(Front/Center/Surround/Surround
Back/Front height/Subwoofer)
speakers.
Set for connecting a tweeter of
SPKR-C
a front speaker to the SURR.
BACK/SPEAKER C terminals and
a woofer of the front speaker to
the FRONT A terminals.
5
Set up "F. Height"
Press u to select "F. Height".
Set to measure the front height
Measure
speakers.
Set not to measure the front
Skip
height speakers.
6
Set up "Front.Sp."
Use ui to select "Front Sp." and
then press to select a speaker.
o p
A Select this to use front speaker A.
B Select this to use front speaker B.
NOTE
If "Mesure" is selected in step 5, select "A". If
"B" is selected, the "F.Height" measurement
cannot be performed.
Confirm the setting
FRANÇAIS FRANÇAIS DEUTSCH DEUTSCH
around items indicate the settings.
7
Proceed to page 8
" Preparation " step 5.
NOTE
After performing Audyssey Auto Setup, do not
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
Return to previous menu
ENGLISH ENGLISH
33