Table of Contents
Advertisement
Acquiring of still pictures and [MP4] motion pictures
(other than [AVCHD] motion pictures)
Preparations:
Turn on the camera and the PC.
Remove the card before using the pictures in the internal memory.
MIC
REMOTE
A USB connection cable (supplied)
•
Check the directions of the connectors, and plug them straight in or unplug them straight out.
(Otherwise the connectors may be bent out of shape which may cause malfunction.)
B Align the marks, and insert.
•
Use a battery with sufficient battery power. If the remaining battery power becomes low while
the camera and the PC are communicating, the status indicator flashes and the alarm beeps.
"
Refer to
Disconnecting the USB connection cable safely
USB connection cable. Otherwise, data may be destroyed.
Connect the camera to a PC via the USB connection cable A
(supplied).
•
Do not use any other USB connection cables except the supplied one. Use of cables
other than the supplied USB connection cable may cause malfunction.
Press 3/4 to select [PC], and then [MENU/SET].
•
If [USB MODE]
automatically connected to the PC without displaying the [USB MODE] selection
screen.
•
When the camera has been connected to the PC with [USB MODE] set to
[PictBridge(PTP)], a message may appear on the PC's screen. Select [Cancel] to close
the screen, and disconnect the camera from the PC. Then set [USB MODE] to [PC]
again.
Operate the PC.
•
You can save the images into the PC by drag and drop the image or the folder with the
image you would like to transfer onto the different folder in the PC.
Note
•
Before inserting or removing a card, turn the camera off and disconnect the USB connection
cable. Otherwise, data may be destroyed.
Connecting to other equipment
(P58)
is set to [PC] in the [SETUP] menu in advance, the camera will be
- 164 -
"
(P165)
before disconnecting the
Advertisement
Table of Contents
