Advertisement
Quick Links
Advertisement
Related Manuals for Elma Instruments 32
Summary of Contents for Elma Instruments 32
- Page 1 Manual Elma 32 Battery Tester EAN: 5706445340323...
-
Page 2: Battery Tester
Elma 32 Battery Tester Elma 32 Battery Tester INSTRUCTION MANUAL ※ Enclosed CD: Software & Protocol Inside. HOLD COMP DATA INTV TIME ¢ X ¢ X F HIGHLOW V RANGE HOLD RANGE MEMORY READ... -
Page 3: Table Of Contents
Elma 32 Battery Tester CONTENTS • 1. Features • 2. Names and functions of parts • 3. Specifications 3.1 General Specifications .............. 5 3.2 Electrical Specifications ............6 • 4. Operation 4.1 Preparation ................6 4.2 Operation .................. 7 4.3 Zero Adjust (REL) ..............7 •... -
Page 4: Names And Functions Of Parts
Elma 32 Battery Tester 2. Names and functions of parts Keys and input / output terminals Power key: Power on /off 2. R READ key: Press R key to show the manual logged readings. Press R READ key again to stop reading. - Page 5 Elma 32 Battery Tester Display HOLD COMP DATA INTV TIME HIGHLOW The reading of the measured impedance (High or Low limit of impedance on the comparator settings) The reading of the measured voltage (High or Low limit of voltage on the comparator settings).
-
Page 6: Specifications
Elma 32 Battery Tester 3. Specifications General Specifications Measuring method: Impedance (AC four-terminal method). A/D conversion: Dual slope method. Display: Dual display LCD and LEDs (comparator output). Sampling rate: 1 set (impedance and voltage measurements) / second. -
Page 7: Electrical Specifications
Elma 32 Battery Tester Electrical Specifications Conditions to guarantee accuracy: Temperature: 23℃ ± 5℃ Humidity: 80%RH or less (no condensation). Zero adjustment: After zero adjustment for each range. Impedance measurement Temperature coefficient: (±0.1% rdg ± 0.5dgs)/℃... -
Page 8: Operation
Elma 32 Battery Tester Operation WARNING Do not attempt to measure DC voltage exceeding 50V. Do not attempt to measure AC voltages. This could result in injury or damage to the unit. Do not attempt to measure the voltage of a generator. This would result in an AC voltage being applied to the voltage generating output terminals, which is dangerous. -
Page 9: Using Comparator Function (99 Sets)
Elma 32 Battery Tester 5. Using Comparator function (99 sets) Comparator The comparator function compares the measured values with preset High and Low limit values for internal impedance and voltage level and determines the range that the measurement should fall into. Then according to the following conditions to light the corresponding LED and sounds a beeper under the WARNING and FAIL cases. -
Page 10: Start / Stop Data Logging
Elma 32 Battery Tester 6. Start / stop data logging Erasing Memory When memory is full, “Full” symbol will appear on the display and logging will be stopping. 1. Press key to turn off the tester. 2. Press and hold M MEMORY key, then press key until the display shows CIr to delete all logged reading in the memory. -
Page 11: Software Installation And Operation
Elma 32 Battery Tester 8. SOFTWARE INSTALLATION and OPERATION For the detailed instruction, please refer to the content of attached CD, which has the complete instruction of software operation and relevant information. Protocol: Are enclosed within the content of CD-ROM, please open the CD-ROM for details. - Page 12 v.20210617 04-09-2024 08:07:38...
Need help?
Do you have a question about the 32 and is the answer not in the manual?
Questions and answers