SolaX Power X1 Series Quick Installation Manual

Quick Installation Guide
X1 Series 3.0KW-6.0KW
Packing Lists
I
Female DC connector * 2
Male DC connector * 2
Inverter
AC connector * 1
(with bracket)* 1
Positive DC pin contact * 2
Documents
Negative DC pin contact * 2
Wi-Fi dongle (optional),
LAN/GRPS dongle (optional)*1
* For the optional accessories, please be subject to the actual delivery.
II
- Unscrew the bracket from the back of the inverter.
- And mark the position(223 mm*30 mm) of three holes.
- Tighten the expansion
III
Cable size: 4 mm²
strip length:
Expansion bolt*3
Flat gasket*3
Self-tapping screw*3
Earth terminal*1
×
Inverter Installation
PH1 cross screwdriver; Torque: 0.8±0.1 N.m
bolt s. - Screw the expansion screws.
PV Connection
-Align the four halves connectors.
7.0 mm
positive DC
pin contact
negative DC
pin contact
cable
clamp contact
+
-
+
-
PV array
- Drill holes with φ10 drill.
- Depth: at least 60 mm.
- Match the inverter with the bracket.
- Screw the cross recessed screw on the right side.
- make sure available space
Torque: 0.8±0.1 N.m
300 mm
300 mm 300 mm
300 mm
300 mm
male plug
female plug
nut
tight nut
+
Note!
+
PV1
- The PV connection
mode as the diagram
+
PV2
shown is not
-
-
allowed!
Inverter