Entering The Setup Mode At Installation - Intermec EasyCoder PX6i User Manual

Chapter 7 — Setup Mode
Entering Setup Mode at Installation
The method of entering the Setup Mode depends on which startup fi les
are stored in the printer's memory, a subject that was more thoroughly
discussed in Chapter 3, "Starting Up."
EasyCoder PX6i with Intermec Shell
• Switch on the power.
• When the display shows the message "Enter=Shell; x sec...", press
<Enter>.
• Press <Setup> (this facility can be used anywhere within Intermec
Shell).
• Set up the printer as described in this chapter.
• Return to Intermec Shell by pressing <Setup>.
EasyCoder PX6i with a custom-made application program
• Normally, there is no need to enter the Setup Mode for custom-made
application programs. Necessary provisions for changing the setup,
manually or automatically, should be provided by the program.
68 EasyCoder PX6i User's Guide (Fingerprint version)