superbrightleds LPGS Series User Manual

Important: Read all instructions prior to installation.
LED Canopy Light
LPGS-SW3C-SP100H
Specifications
Model
Mounting
Operating Temperature
Plate
IP Rating
Check product label for specific electrical
specifications related to installation.
Locking
Improper installation will void warranty.
Screw
Pole/Pendant Mounting Installation
1. Remove supply power.
2. Select CCT and wattage.
3. Remove conduit plug.
4. Connect wiring.
5. Securely attach rear housing to pipe.
G3/4" Pipe
G3/4" Thread
LPGS-SW3C-SP100H
-40°–113° F (-40°–45° C)
IP65
Locking
Screw
Safety and Notes
• Product should be installed by a certified electrician in accordance with
applicable national, state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that main power source and
circuit breakers are switched off before performing any installation or wiring
procedures.
• Avoid looking directly into lamp when illuminated.
• Ensure all mounts are securely attached and will support weight of the
fixture. Failure to properly support the fixture may result in damage or injury,
for which the manufacturer does not assume responsibility.
Wiring Diagram
120–277 VAC
Supply
0–10 V Dimmer
CCT and Wattage Selection
1. Remove plug.
2. Select desired CCT and wattage
3. Secure plug.
Rev Date: V1 12/12/2022
4400 Earth City Expy, St. Louis, MO 63045
User Manual
LPGS Series
Black
L L
White
N N
Green
GND GND
Purple
+ +
Gray
– –
CCT Adjust
DIP Switch
Wattage Adjust
DIP Switch
Mounting
Plate
866-590-3533 superbrightleds.com
Locking
Screw
Black
White
Green
Purple
Gray/Pink