Helo 1900584 Installation And User Manual

SAUNA HEATER
Type 1900584
Type 1960512
Type 1960515
Type 1901584
Type 1961512
Type 1961515
CONTROL PANEL
Type 0518-2-1517
THE FUNCTIONS OF THE CONTROL PANELS ARE EXPLAINED IN A SEPARATE INSTALLATION
AND USER´S MANUAL FOR THE CONTROL PANEL.
MOUNTING OF THE HEATER
See next page for mounting instructions. Please take note of the following, when installing the heater.
- Stick to the give measurements
- We recommend wooden panels to be used for walls and ceilings
- The given volumes in the enclosed table only apply if the sauna is well insulated and if the surface material is of
wooden panels
- Only one heater may be installed per sauna
- The sauna heater must not be installed in a niche nor must a solid guard construction be built around the heater
- Only a gualified electician is allowed to connect the heater to the net in accordance with applying electrical
regulations.
INSTALLATION TO THE NET
From the solid installation the connecting cable of the heater has to be rubber cable and must not be lighter built
than flexible oilresistant rubber cable H07RN-F.
SAUNA ROCKS
We recommend you to rinse the rocks before loading them into the heater. The bigger rocks are to be loaded at
the bottom and the smaller ones on top. The rocks must not be too tightly loaded, because this will stop the air
flowing through the heater. The rocks must not be too tightly loaded around the elements either. Please pay extra
attentiont when loading the rock compartment. The rocks should cover the elements. The r ocks have to be
changed at the latest when the rocks start to fall into small pieces, because this will effect the air flow through the
heater. When changing the rocks, please use rocks of high guality.
INSTALLATION AND USER`S MANUAL
(When using a separate control panel)
Type 0518-2-151705
Heiss
Vorw ahl
H eizzeit Uhrzeit Stunde M inute
Tem p.- Warm
An Aus
Auto
Vorw ahl
Soft
Licht
I
0
1
7013995
314 SKLF 6 B