Battery Level Indication; Low-Voltage Warning; Usage And Maintenance - Fenix HM62-T Manual

3. Once charging is completed, be sure to unplug the charging cable and insert the battery in accordance with
the polarity marks, then screw the battery cover back on.

Battery Level Indication

With the light switched off, single click the side switch to check the battery status, the indicator in the switch will
last for 3 seconds. Each time the light is turned on, the indicator will show the current
battery level and will last for 3 seconds.
Green light on: 100% - 80%
Green light flashes: 80% - 50%
Red light on: 50% - 20%
Red light flashes: 20% - 1%
*Note: This only works with a Fenix ARB-L18 Series battery.
Intelligent Overheat Protection
The lamp will accumulate a lot of heat when used at high output levels for extended periods. When the lamp
reaches a temperature of 50°C/122°F or above, it will automatically step down a few lumens to reduce the
temperature. When the temperature drops below 50°C/122°F, the lamp will gradually recall the preset output
level.

Low-voltage Warning

When the voltage level drops below the preset level, the headlamp is programmed to downshift to a lower
brightness level until Low output is reached. When this happens in Low output, the lamp blinks 3 times every 5
minutes on the Low output of white light mode to remind users to recharge or replace the battery.
*Note: This only works with a Fenix ARB-L18 Series battery.
Headband Assembly
Notice: The headband is factory assembled by default.
Rotate the dial clockwise to tighten the headband, and rotate the dial counterclockwise to loosen the headband.
When the headband hits its maximum length, keep rotating the dial and the operation direction will reverse.

Usage and Maintenance

◎Disassembling the sealed body can cause damage to the lamp and will void the warranty.