Maintenance; Cleaning; Automatic Scanner Replacement; Asr Network Configuration - Datalogic DX6400 Reference Manual

Datalogic laser scanner reference manual

Hide thumbs Also See for DX6400:

Table of Contents

MAINTENANCE

5 MAINTENANCE

Clean the laser beam output window periodically for correct operation of the scanner (see

Figure A in chapter "General View").

Dust, dirt, etc. on the window may alter the reading performance.

Repeat the operation frequently in particularly dirty environments.

Use soft material and alcohol to clean the window and avoid any abrasive substances.

Clean the window of the DX6400 when the scanner is turned off or at

least when the laser beam is not active.

WARNING

The Datalogic Automatic Scanner Replacement (ASR) procedure allows restoring system

functioning automatically after one or more scanners are replaced in a Master/Slave

Lonworks network.

The ASR procedure is principally used for PackTrack™ configurations, since it restores the

PackTrack™ calibration from the slave scanner to be substituted to the new scanner.

The Master must be prepared at the time of installation in order for this procedure to work

correctly.

1. On the Master scanner, check the Modify & Backup Lon Slave Scanner

Configuration parameter in Genius™ and configure the Lonworks Slave Scanner

Common Parameters (Code and Reconstruction Parameters).

2. Enable the ASR procedure through the Enable A.S.R. parameter in the Master

configuration.

3. Send the configuration to the Master EEPROM to force the Slave Operating Mode, Code

Reading Symbologies, Reconstruction parameters and store all the Slave PackTrack™

calibration tables.

Now the Slave scanners are configured through the Master and the ASR procedure is

implemented.

4. Save this configuration to file (.ddc).

Table of Contents