Setting The Device Boot Order - HP Vectra VEC 7 Maintenance Manual

NOTE
4 Troubleshooting Your PC

Setting the Device Boot Order

Setting the Device Boot Order
To select the drive to start (boot) from, you must enter the Setup
program and go to
Advanced - Advanced CMOS Setup
select the 1st, 2nd, 3rd, and 4th Boot Devices. Connecting a hard disk
drive to the IDE master connector does not ensure that the PC will
boot on that hard disk drive.
The first time you start your PC, the PC will by default boot from the
hard disk drive connected to the Master IDE connector on the Primary
IDE cable (IDE-0).
The drive positions on the two IDE cables are:
Cable
Primary IDE Master
Primary IDE Slave
Secondary IDE Master
Secondary IDE Slave
When booting from a different hard disk drive, make sure you know its
physical position on the cable.
84 English
Connector BIOS ID (in Setup Program)
IDE-0
IDE-1
IDE-2
IDE-3
. You can then