Checking V-Belt - Grizzly G0516 Owner's Manual

Figure 63. Ball fitting lubrication points.
Gears—Apply a minimal amount of oil to the
teeth of the end gears after assembly and each 8
hours of actual use. Avoid getting oil on the belt
or pulleys when lubricating. Also, regularly apply
lubrication to all the ball fittings drive box.
Long Leadscrew—Apply a minimal amount
directly on the rack every 8 hours of actual use.
Carriage Rack—Apply a minimal amount directly
on the rack every 8 hours of actual use.
Mill/Drill Rack & Pinion—Apply a minimal
amount directly on the rack every 8 hours of
actual use.
G0516 Lathe/Mill -35-