Grizzly G0516 Owner's Manual page 30

3.
Thread the extra fixed-shaft gear into mount-
ing location "A" as shown in Figure 45.
Figure 45. Extra fixed-shaft gear mounted in
position "A."
4. When the machine is shipped, a fixed-shaft
gear is in position "B." Remove that fixed-
shaft gear from mounting location "B" and
thread it into mounting location "C" as shown
in Figure 46.
Figure 46. Fixed-shaft gear mounted in
position "C."
-28-
A
C
5.
Loosen the cap screw on the gear bracket,
and pivot the bracket so the top gear meshes
with the fixed-shaft gear that is in position "C,"
as shown in Figure 47.
Figure 47. All gears in mesh for reverse
threading operations.
6. Tighten the cap screw in the gear bracket to
keep it from pivoting.
7. Spin the lathe chuck by hand to ensure that
the gears do not bind.
8.
Replace the cover and test run the machine
before proceeding with your specific opera-
tion.
G0516 Lathe/Mill