Section 9: Service Adjustments; About Service; Gibs - Grizzly G0516 Owner's Manual

SECTION 9: SERVICE ADJUSTMENTS

Disconnect power to the
machine when perform-
ing any adjustments or
maintenance. Failure to
do this may result in seri-
ous personal injury.

About Service

This section is designed to help the operator with
adjustments that were made at the factory and
might also need to be made during the life of the
machine.
This section is provided for your convenience—
it is not a substitute for the Grizzly Service
Department. If any adjustments arise that are not
described in this manual, then feel free to call the
Grizzly Service Department.
Similarly, if you are unsure of how to perform
any procedure in this section, the Grizzly Service
Department will be happy to guide you through
the procedures or help in any other way.
-36-

Gibs

There are four gib adjustments for the Model
G0516—the cross-slide gib, the compound slide
gib, the apron gib, and the mill/drill downfeed gib.
NOTICE
When adjusting gibs, keep in mind that the
goal of gib adjustment is to remove unneces-
sary sloppiness without causing the slides to
bind. Loose gibs may cause poor finishes on
the workpiece and may cause undue wear on
the slide. Over-tightening may cause prema-
ture wear on the slide, leadscrew and nut.
Cross-slide Gib—The gib on the cross-slide
is adjusted by tightening or loosening the 4 gib
screws located on the right-hand side of the slide.
See Figure 64. Before adjusting the gib screws,
loosen their jam nuts.
Figure 64. Cross slide gib screws.
The gib is held in place by the setscrews. DO
NOT overtighten. The gib is properly adjusted
when a slight drag is detected while turning the
hand crank. This drag should be evenly distribut-
ed among the 4 setscrews, so adjust each screw
until a slight drag is detected while the hand crank
is turned.
G0516 Lathe/Mill