Attach Mill/Drill To Lathe; Install Belts - Grizzly G0516 Owner's Manual

Attach Mill/Drill to
Lathe
To attach the mill/drill unit to the lathe body:
1.
Get the help of an assistant.
2.
Locate the included nut that fits on the large
bolt in the mounting bracket, so you have it
ready for the next step.
3. Place the bottom end of the mill/drill unit over
the mounting bolt and up against the mount-
ing bracket, then have your assistant thread
the nut onto the bolt as shown in Figure
5—but DO NOT tighten the nut yet.
Figure 5. Threading nut onto bolt with mill/drill
unit in place against mounting bracket.
G0516 Lathe/Mill
4.
Align the indicator on the mounting bracket
with the "0" line on the mill/drill swivel scale,
as shown in Figure 6.
Figure 6. Mill/drill swivel scale aligned with hub
indicator line in the "0" position.
5. Now, tighten the large nut that attaches the
mill/drill unit to the lathe hub bracket.

Install Belts

Before the lathe can be test run, the V-belt and
cogged belt must be installed on the pulleys/
sprockets. Before the belts can be installed, the
pulleys and sprocket must be cleaned of the ship-
ping grease.
Install the V-belt and cogged belt as shown in
Figure 7.
Cogged Belt
Figure 7. V-belt and cogged belt installed.
V-Belt
-11-