Router Front And Rear Panels - NETGEAR FVX538 - ProSafe VPN Firewall 200 Router Reference Manual

ProSafe VPN Firewall 200 FVX538 Reference Manual

Router Front and Rear Panels

The ProSafe VPN Firewall 200 front panel shown below contains the port connections, status
LEDs, and the factory defaults reset button.
1 2
Figure 1-1
Table 1-1 describes each item on the front panel and its operation.
Table 1-1. Object Descriptions
Object Activity
On (Green)
1. Power
Off
LED
2. Test LED On (Amber)
Blinking (Amber)
Off
Two RJ-45 WAN ports N-way automatic speed negotiation, Auto MDI/MDIX.
3. WAN
Ports
Link/Act LED
and
On (Green)
LEDs
Blinking (Green)
Off
100 LED
On (Green)
Off
Active LED
On (Green)
On (Amber)
Off
1-6
3 4
Description
Power is supplied to the firewall.
Power is not supplied to the firewall.
Test mode: The system is initializing or the initialization has failed.
Writing to Flash memory (during upgrading or resetting to defaults).
The system has booted successfully.
The WAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the WAN port.
The WAN port has no link.
The WAN port is operating at 100 Mbps.
The WAN port is operating at 10 Mbps.
The WAN port has a valid Internet connection.
The Internet connection is down or not being used because the port
is available for failover in case the connection on other WAN port
fails.
The WAN port is either not enabled or has no link.
v1.0, March 2009
5 6 7
Introduction