Router Front Panel - NETGEAR ProSafe FVS338 Reference Manual

FVS338 ProSafe VPN Firewall 50 Reference Manual

Router Front Panel

The ProSafe VPN Firewall 50 front panel shown below contains the port connections, status
LEDs, and the factory defaults reset button.
Power
LED
Figure 1-1
The table below describes each item on the front panel and its operation.
Table 1-1. Object Descriptions
Object Activity
Power LED On (Green)
Off
Test LED On (Amber)
Blinking (Amber)
Off
MDM LED On (Green)
Blinking (Green)
Off
Internet Link/Act LED
LEDs On (Green)
Blinking (Green)
Off
100 LED
On (Green)
Off
1-6
Test Modem Internet
LED LED LEDs
Description
Power is supplied to the router.
Power is not supplied to the router.
Test mode: The system is initializing or the initialization has failed.
Writing to Flash memory (during upgrading or resetting to defaults).
The system has booted successfully.
The serial port has successfully connected to an ISP and received an
IP Address.
Server data is being transmitted or received by the serial port.
The serial port has no link.
The WAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the WAN port.
The WAN port has no link.
The WAN port is operating at 100 Mbps.
The WAN port is operating at 10 Mbps.
v1.0, September 2006
Local
LEDs
Introduction