NETGEAR FVX538 - ProSafe VPN Firewall 200 Router Reference Manual page 139

d. Under Virtual Adapter pull-down menu, select Preferred. The Internal Network IP
Address should be 0.0.0.0.
Note: If no box is displayed for Internal Network IP Address, go to Options/
e. Select your Internet Interface adapter from the Name pull-down menu.
Figure 5-28
3. On the left-side of the menu, select Security Policy.
a. Under Security Policy, Phase 1 Negotiation Mode, check the Aggressive Mode radio
button.
b. Check the Enable Perfect Forward Secrecy (PFS) radio button, and select the Diffie-
Hellman Group 2 from the PFS Key Group pull-down menu.
c. Enable Replay Detection should be checked.
4. Click on Authentication (Phase 1) on the left-side of the menu and select Proposal 1. Enter the
Authentication values to match those in the VPN firewall ModeConfig Record menu.
Virtual Private Networking
ProSafe VPN Firewall 200 FVX538 Reference Manual
Global Policy Settings, and check the box for "Allow to Specify Internal
Network Address."
remote_id.com
v1.0, March 2009
5-35