NETGEAR FVX538 - ProSafe VPN Firewall 200 Router Reference Manual page 33

Figure 2-3
2. Click Apply to apply the settings. Click Reset to return to the previous settings.
3. Select the WAN2 Traffic Meter tab and repeat steps 1 through 3 to set the Traffic Meter the
the WAN2 port.
Table 2-2. Traffic Meter Settings
Parameter Description
Enable Traffic Meter Check this if you wish to record the volume of Internet traffic passing through the
Router's WAN1 or WAN2 port. WAN1 or WAN2 can be selected by clicking the
appropriate tab; the entire configuration is specific to each wan interface.
• No Limit - If this is selected specified restriction will not be applied when traffic limit
• Download only - If this is selected the specified restriction will be applied to the
• Both Directions - If this is selected the specified restriction will be applied to both
Enable Monthly Limit Use this if your ISP charges for additional traffic. If enabled, enter the monthly
volume limit and select the desired behavior when the limit is reached.
Note: Both incoming and outgoing traffic are included in the limit.
Connecting the FVX538 to the Internet
ProSafe VPN Firewall 200 FVX538 Reference Manual
is reached.
incoming traffic only
incoming and outgoing traffic only
v1.0, March 2009
2-7