The Router's Rear Panel - NETGEAR ProSafe FVS124G Reference Manual

Reference Manual for the ProSafe VPN Firewall 25 with 4 Gigabit LAN and Dual WAN Ports
Table 2-1. FVS124G front panel
Object Activity
PWR LED On (Green)
Off
TEST LED On (Amber)
Blinking (Amber)
Off
WAN Port Link/Act LED
LEDs On (Green)
Blinking (Green)
Off
100 LED
On (Green)
Off
Active LED
On (Green)
On (Amber)
Off
Gigabit LAN Link/Act LED
Port LEDs On (Green)
Blinking (Green)
Off
Speed LED
On (Green)
On (Amber)
Off

The Router's Rear Panel

The rear panel of the FVS124G ProSafe VPN Firewall 25 with 4 Gigabit LAN and Dual WAN
Ports (Figure 2-2) contains the factory defaults reset button, LAN and WAN ports, and DC power
input connection.
Introduction
Description
Power is supplied to the firewall.
Power is not supplied to the firewall.
Test mode: The system is initializing or the initialization has failed.
Writing to Flash memory (during upgrading or resetting to defaults).
The system has booted successfully.
The WAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the WAN port.
The WAN port has no link.
The WAN port is operating at 100 Mbps.
The WAN port is operating at 10 Mbps.
The WAN port has a valid Internet connection.
The Internet connection is down or not being used.
The WAN port is either not enabled or has no link.
The LAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the LAN port.
The LAN port has no link.
The LAN port is operating at 1,000 Mbps.
The LAN port is operating at 100 Mbps.
The LAN port is operating at 10 Mbps.
202-10085-01, March 2005
2-7