NETGEAR FVX538 - ProSafe VPN Firewall 200 Router Reference Manual page 57

Figure 3-5
4. Select Active to make this route effective.
5. Select Private if you want to limit access to the LAN only. The static route will not be
advertised in RIP.
6. Enter the Destination IP Address to the host or network to which the route leads.
7. Enter the IP Subnet Mask for this destination. If the destination is a single host, enter
255.255.255.255.
8. Enter the Interface which is the physical network interface (WAN1, WAN2, or LAN) through
which this route is accessible.
9. Enter the Gateway IP Address through which the destination host or network can be reached
(must be a firewall on the same LAN segment as the firewall).
10. Enter the Metric priority for this route. If multiple routes to the same destination exit, the route
with the lowest metric is chosen. (value must be between 1 and 15),
11. Click Reset to discard any changes and revert to the previous settings.
12. Click Apply to save your settings. The new static route will be added to Route table.
You can edit the route's settings by clicking Edit in the Action column adjacent to the route.
LAN Configuration
ProSafe VPN Firewall 200 FVX538 Reference Manual
v1.0, March 2009
3-13