Installing the Switch
Rack Mounting
Warning
Note
Catalyst 3750 Switch Hardware Installation Guide
3-18
To prevent bodily injury when mounting or servicing this unit in a rack, you
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
•
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
•
When mounting this unit in a partially filled rack, load the rack from the bottom to the
top with the heaviest component at the bottom of the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers before mounting
or servicing the unit in the rack.
To install the switch in a 19-inch or 24-inch rack (24-inch racks require optional
mounting hardware), follow the instructions described in these procedures:
Removing Screws from the Switch, page 3-19
•
Attaching Brackets to the Catalyst 3750G-24TS Switch, page 3-20
•
Attaching Brackets to the Catalyst 3750-24TS, 3750G-24T, 3750G-12S, and
•
3750-48TS Switches, page 3-25
Mounting the Switch in a Rack, page 3-28
•
Attaching the Cable Guide, page 3-30
•
Installing the switch in a 24-inch rack requires an optional bracket kit not included
with the switch. You can order a kit containing the 24-inch rack-mounting
brackets and hardware from Cisco. For the Catalyst 3750G-24TS switches, order
part number RCKMNT-3550-1.5RU=. For the Catalyst 3750-24TS, 3750G-24T,
3750G-12S, and 3750-48TS switches, order part number RCKMNT-1RU=.
Chapter 3
Switch Installation
78-15136-02