Completing The Setup Program - Cisco ME-C3750-24TE-M Hardware Installation Manual

Appendix D Quick Setup By Using the CLI-Based Setup Program

Completing the Setup Program

Note
Step 1
Step 2
Step 3
Step 4
78-15136-02
If your switches are stacked and there are multiple console connections to
individual switches in the stack, the initial setup dialog appears in the first console
where the user presses Enter.
Follow these steps to complete the setup program and to create an initial
configuration for the switch:
Enter Yes at the following two prompts.
Would you like to enter the initial configuration dialog? [yes/no]:
yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]: yes
Enter a host name for the switch, and press Return.
On a command switch, the host name is limited to 28 characters; on a member
switch to 31 characters. Do not use -n, where n is a number, as the last character
in a host name for any switch.
Enter host name [Switch]: host_name
Enter an enable secret password, and press Return.
The password can be from 1 to 25 alphanumeric characters, can start with a
number, is case sensitive, allows spaces, but ignores leading spaces. The secret
password is encrypted and the enable password is in plain text.
Enter enable secret: secret_password
Enter an enable password, and press Return.
Enter enable password: enable_password
Entering the Initial Configuration Information
Catalyst 3750 Switch Hardware Installation Guide
D-11