Appendix D
Quick Setup By Using the CLI-Based Setup Program
Starting the Terminal Emulation Software
Step 1
Step 2
Step 3
Connecting to a Power Source
Step 1
Step 2
Step 3
78-15136-02
Before you power on the switch, start the terminal emulation session so that you
can see the output display from the power-on self-test (POST).
The terminal-emulation software—frequently a PC application such as
Hyperterminal or ProcommPlus—makes communication between the switch and
your PC or terminal possible.
Start the terminal-emulation program if you are using a PC or terminal.
Start a terminal-emulation session.
Configure the baud rate and character format of the PC or terminal to match these
console port default characteristics:
9600 baud
•
8 data bits
•
•
1 stop bit
No parity
•
None (flow control)
•
Follow these steps to connect to a power source:
Connect one end of the supplied AC power cord to the power connector on a
switch rear panel. See
Connect the other end of the power cable to a grounded AC outlet.
(Optional) If you have a stack, power on all the switches in the stack.
If you have stacked your switches, refer to the
Note
section on page 3-13
Figure
D-4.
for more information.
Catalyst 3750 Switch Hardware Installation Guide
Starting the Terminal Emulation Software
"Powering Considerations"
D-9