Auto Power Off Function; System Lock Function - Eiki EIP-4500 Owner's Manual

Auto Power Off Function

Menu operation Page 56
Example: "Options (1)" screen menu for
INPUT 1 (RGB) mode
Description of Auto Power Off
Selectable items
The projector automatically enters the
ON standby mode when no input signal is
detected for 15 minutes or longer.
The "Auto Power Off" function will be
OFF
disabled.
Note
• When "Auto Power Off" is set to "ON", 5 min-
utes before the projector enters the standby
mode, the message "Enter STANDBY mode in
X min." will appear on the screen to indicate
the remaining minutes.
Description

System Lock Function

This function prevents unauthorized use of the pro-
jector. Once this function is activated, users must enter
the correct keycode each time the projector is turned
on. We suggest you record the keycode in a safe place
where only authorized users have access.
Info
• If you lose or forget your keycode, contact your
nearest EIKI Authorized Dealer or Service
Center. Even if the product warranty is valid, the
keycode reset will incur a charge.
Menu operation Page 58
Example: "Options (1)" screen menu for
INPUT 1 (RGB) mode
Setting the keycode
1
Select "System Lock" on the "Op-
tions (1)" menu, then press | | | | | .
• A message is displayed.
• Read this message, and press
2
Press the 4 buttons on the remote
control or on the projector to enter
the preset keycode in "Old Code".
• When setting the keycode for the first time,
press " on the projector for four times.
.
79