Troubleshooting - Eiki EIP-4500 Owner's Manual

Troubleshooting

Problem
No picture and no sound
or projector does not start.
Sound is heard but no
picture appears.
Color is faded or poor.
Picture is blurred;
noise appears.
Picture appears but no
sound is heard.
An unusual sound is
occasionally heard
from the cabinet.
Maintenance
indicator illuminates or
blinks in red.
• Projector power cord is not plugged into the wall outlet.
• Power to the external connected devices is off.
• The selected input mode is wrong.
• Cables incorrectly connected to side panel of the projector.
• Remote control batteries have run out.
• External output has not been set when connecting notebook computer.
• Cables incorrectly connected to the side panel of the projector.
• "Bright" is set to minimum position.
• The "BLACK SCREEN" function is working.
• Image adjustments are incorrectly set.
(INPUT 1, INPUT 2, INPUT 3 only)
• Input signal type (RGB/Component) is incorrectly set.
(INPUT 4, INPUT 5 only)
• Video Input system is incorrectly set.
• Adjust the focus.
• The projection distance exceeds the focus range.
(Computer Input only)
• Perform "Fine Sync" Adjustments. ("Clock" Adjustment)
• Perform "Fine Sync" Adjustments. ("Phase" Adjustment)
• Noise may appear depending on the computer.
• Cables incorrectly connected to side panel of the projector.
• Volume is set to minimum.
• The "MUTE" function is working.
• The "Speaker" menu is set to "OFF".
• If the picture is normal, the sound is due to cabinet shrinkage
caused by room temperature changes. This will not affect
operation or performance.
• See "Maintenance Indicators".
Check Page
37
—
45
27—36
17
27
27—36
60
50
60
63
76
40
22
68
68
—
27—36
46
46
73
—
91
99