Connecting To A Computer; Connecting With The Rgb Cable - Eiki EIP-4500 Owner's Manual

Connecting to a Computer

Before connecting, ensure that the power cord of the projector from the AC outlet is un-
plugged, and that the devices to be connected are turned off. After making all connections,
turn on the projector and then the other devices. When connecting a computer, ensure that
it is the last device to be turned on after all the connections are made.
Ensure that you have read the owner's manuals of the devices to be connected before making connections.
Note
• See page 97 "Computer Compatibility Chart" for a list of computer signals compatible with the projector.
Use with computer signals other than those listed may cause some of the functions to not work.
• Connecting computers other than the recommended types may result in damage to the projector, the
computer, or both.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest
Macintosh Dealer.
• Depending on the computer you are using, an image may not be projected unless the signal
output setting of the computer is switched to the external output. Refer to the computer owner's
manual for switching the computer signal output settings.

Connecting with the RGB Cable

Computer
To audio output terminal
Note
• With this connection, the projector is not compatible to the sync on green signals.
• When using the ø3.5 mm mono audio cable, the volume level will be half of when using the ø3.5 mm stereo audio cable.
"Plug and Play" function (when connecting to a 15-pin terminal)
■ This projector is compatible with VESA-standard DDC 1/DDC 2B. The projector and a VESA DDC com-
patible computer will communicate their setting requirements, allowing for quick and easy setup.
■ Before using the "Plug and Play" function, be sure to turn on the projector first and the connected
computer last.
Note
• The DDC "Plug and Play" function of this projector operates only when used in conjunction with a VESA
DDC compatible computer.
To INPUT 1 terminal
To RGB output
terminal
RGB cable
Supplied
accessory
Side view
To AUDIO input (1) terminal
ø3.5 mm stereo or mono audio cable
(commercially available)
RGB cable
27