Connecting To Video Equipment That Has Component Output Terminals - Eiki EIP-4500 Owner's Manual

Connecting to Video Equipment That Has Component
Output Terminals
When connecting the video equipment that has component output terminals to the INPUT 2
terminals, use the BNC to RCA adaptors (commercially available).
Video Equipment
To audio output
terminals
Note
• ø3.5 mm stereo minijack to RCA audio cable (commercially available) is required for audio input.
• Select "480P/525P" or "576P/625P" for "Special Modes" on the "Fine Sync" menu, if necessary. (See page
69.)
• When you connect video equipment with a 21-pin RGB output (Euro-scart) to the projector, use a com-
mercially available cable that fits in the projector terminal you want to connect.
• The projector does not support RGBC signals via the Euro-scart.
To component video
output terminals
Y(green)
P (C )(blue)
B B
P (C )(red)
R R
Side view
To INPUT 2 terminals
(R(P )/G/G sync (Y)/B (P ))
R B
BNC to RCA adaptors
(commercially available)
Component video cable
(commercially available)
ø3.5 mm stereo minijack to RCA audio cable
(commercially available)
To AUDIO input (2, 3)
terminal
33