Connecting The Power Supply; Mounting Your Router; Mounting On A Table - Cisco 888 G.SHDSL Router with 3G - 888 G.SHDSL Router Hardware Installation Manual

Mounting Your Router

Connecting the Power Supply

To connect the power supply, follow the steps in
The device is designed to work with TN power systems.
Warning
Warning This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 16A international) is used on the
phase conductors (all current-carrying conductors).
This equipment is intended to be grounded. Ensure that the host is connected to earth ground during
Warning
normal use.
Figure 2-10 Connecting the Power Supply
Mounting Your Router
You can mount your router on one of the following surfaces:
•
•

Mounting on a Table

You can mount your router on a table or other horizontal surface. Use the following guidelines:
Cisco 800 Series Routers Hardware Installation Guide
2-18
HU B
N O H U
2. Connect power
supply cable.
Table or other horizontal surface
Wall or other vertical surface
Figure 2-10.
1. Press power switch to standby (
C is c o 8
ET HE RN
0 3
ET 10 BA
B
SE T
CO NS O
LE
IS DN S/
T
PH ON E
0
1
2
3
1
Desktop power supply
3. Connect power cord
to power supply.
Chapter 2
).
Cisco 803 router
2
5. Press power switch to on ( ).
4. Connect other end
of power cord to
electrical outlet.
Installation
78-5373-04