Back Panels - Cisco 888 G.SHDSL Router with 3G - 888 G.SHDSL Router Hardware Installation Manual

Back Panels

Figure 1-3
Back Panels
The figures in this section show the back panel of each of the Cisco 800 series routers.
If the symbol of suitability ( ) appears above a port, you can connect the port directly to a public
network that follows the European Union standards.
Warning If the symbol of suitability with an overlaid cross (
port to a public network that follows the European Union standards. Connecting the port to this type
of public network can cause severe injury or damage your router.
Figure 1-4 Cisco 801 Router Back Panel
Link LED
Indicates state
of Ethernet
port. On when
connected.
Cable lock
Use cable
lock to
physically
secure
router.
Cisco 800 Series Routers Hardware Installation Guide
1-4
Cisco 804 IDSL Front Panel
IDSL
ET HE RN ET
Ethernet port ISDN BRI S/T port
Connect Ethernet Connect to external
NT1 or ISDN wall jack.
network device.
C is c o 8
H U B
E T H E R
L IN K
N E T
N O H U
B
C O N S O
1 0 B A S
E T
HUB/NO HUB button
(for Ethernet port)
Console port
Determines cable
Connect PC or
type for Ethernet
terminal.
device connection.
) appears above a port, you must not connect the
Power switch
l = On.
= Standby or no power output.
0 1
L E
IS D N S /T
Locking power
connector
Connect power
supply.
Chapter 1 Overview
78-5373-04