Connecting A Terminal Or Pc; Connecting The Power Supply - Cisco 828 Quick Start Manual

Connecting Cables to the Router

Connecting a Terminal or PC

You can connect either a terminal or a PC to the router. Use the terminal or PC to configure the software,
using the command-line interface (CLI), or to troubleshoot problems that arise. To connect a terminal or
PC, follow the steps in
Figure 5

Connecting the Power Supply

To connect the power supply, follow the steps in
Warning The device is designed to work with TN power systems.
Warning This product relies on the building's installation for short-circuit (overcurrent)
protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S.
(240 VAC, 16A international) is used on the phase conductors (all current-carrying
conductors).
This equipment is intended to be grounded. Ensure that the host is connected to earth
Warning
ground during normal use.
Cisco 828 Router and SOHO 78 Router Cabling and Setup Quick Start Guide
6
Figure 5.
Connecting a Terminal or PC
TO HU B
ET HE RN M o d e l C
TO PC
ET 10 BA
is c o 8 2 8
SE T
CO NS OL
E
4
3
2
1
1. Connect light blue cable
to CONSOLE port.
2. If necessary, connect other end of
cable to DB-9-to-RJ-45 adapter.
Cisco 828 router
G. SH DS
L
+5 VD C
3. Connect DB-X
connector to
terminal or PC.
DB-X-to-RJ-45
adapter
Figure 6.
78-12839-01