Using The Show Mpf Interface Command - Cisco 7301 Installation And Configuration Manual

Enabling the Second Processor
3333333333333333333333333333333333333333333333333333333333
3333333333333333333333333333333333333333333333333333333333
100
90
80
70
60
50
40
30 #################
20 #################
10 #################
0....5....1....1....2....2....3....3....4....4....5....5....
1
60
80
100 *
90 *
80 *
70 **
60 **
50 **
40 ##
30 ##
20 ##
10 ##
0....5....1....1....2....2....3....3....4....4....5....5....6....6....7.

Using the show mpf interface Command

Using the show mpf interface command without arguments shows the interface information for all
Gigabit Ethernet interfaces and subinterfaces. This command is supported only for physical interfaces.
There is no support for virtual access interface.
Router# show mpf interface
Name
Gi0/1
Gi0/1
Gi0/1.100
Gi0/1.101
Gi0/1.102
Gi0/1.105
Gi0/1.106
Gi0/1.107
Cisco 7301 Installation and Configuration Guide
3-24
0 5 0 5 0
CPU% per second (last 60 seconds)
0 5 0 5 0
CPU% per minute (last 60 minutes)
* = maximum CPU% # = average CPU%
0 5 0 5
CPU% per hour (last 72 hours)
* = maximum CPU% # = average CPU%
Index State Counter
0 up RX packets
RX bytes
TX packets
TX bytes
RX punts
TX punts
1 up
100 up RX packets
RX bytes
TX packets
TX bytes
RX punts
101 up
102 up
105 up
106 up
107 up
Chapter 3
5 0 5 0 5
5 0 5 0 5
0 5 0 5 0
Count
1004
158632
5004
790632
32961
85972
1004
158632
5004
790632
25
Starting and Configuring the Router
5 0 5 0
OL-5418-07