About The Sfp Gbic Module - Cisco 7301 Installation And Configuration Manual

Chapter 1 Cisco 7301 Overview
Table 1-2 Cisco 7301 Router Installation Checklist
Task
Date router received
Router and all accessories unpacked
Types and numbers of interfaces verified
Safety recommendations and guidelines reviewed
Installation Checklist copied
Site log established and background information entered
Site power voltages verified
Site environmental specifications verified
Required passwords, IP addresses, device names, and so on, available
Required tools available
Network connection equipment available
Router mounted in rack (optional)
Cable-management bracket installed (optional but recommended)
AC power cable(s) connected to AC source(s) and router; cable-retention clip secured
DC power cable(s) connected to DC source(s) and router
Network interface cables and devices connected
ASCII terminal attached to console port
Console port set for 9600 baud, 8 data bits, no parity, and 1 stop bits (9600 8N1)
System power turned on
System boot complete (STATUS LED is on)
I/O ports and port adapter are operational (see
Correct hardware configuration displayed after system banner appears

About the SFP GBIC Module

You may have ordered a SFP (small form-factor pluggable) Gigabit Interface Converter (GBIC) module
with your Cisco 7301 router. You must install the SFP GBIC module. It is shipped separately to prevent
damage during shipment. After reading this section, use the installation instructions in the
the SFP GBIC Module" section on page 1-11
For ease of installation, insert the SFP GBICmodule in the router while it is powered down and before
placing it in a rack.
The SFP GBIC port is a 1000-Mbps optical interface in the form of an LC-type duplex port that supports
IEEE 802.3z interfaces compliant with the 1000BASEX standard. Gigabit Ethernet SFP GBIC models
GLC-SX-MM, GLC-LH-SM, and GLC-ZX-SM are supported in the Cisco 7301 router, as well as the
Cisco 1000BASE-T SFP. In addition, a variety of Coarse Wave Division Multiplexing (CWDM) SFPs
are supportedon the Cisco 7301. The cabling information is the same for all optical SFPs.
OL-5418-07
Figure 1-3 for specific LED information)
the to install the SFP GBIC modules.
About the SFP GBIC Module
Cisco 7301 Installation and Configuration Guide
Verified
By Date
"Installing
1-9