Installing The Sfp Gbic Module - Cisco 7301 Installation And Configuration Manual

Chapter 1 Cisco 7301 Overview
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94

Installing the SFP GBIC Module

Figure 1-6
1
Use the following procedure to install a SFP GBICmodule:
Step 1 Attach an ESD-preventive wrist strap between you and an unpainted chassis surface.
Locate the label on the SFP GBIC module and turn the SFP GBIC module so the label is on top and the
Step 2
alignment groove is down.
Note
Insert the SFP GBIC module into SFP GBIC port 0/1, 0/2, or 0/3. The SFP GBIC module snaps into place
Step 3
when you have completely and properly inserted it.
Repeat Step 2 if you are inserting a second or third SFP GBIC module.
Step 4
Do not remove the plug from the SFP GBIC optical bores until you are ready to install the network
Note
interface optical fiber cable. Save the plug for future use.
This completes the SFP GBIC module installation procedure.
OL-5418-07
Inserting a SFP GBIC Module into the Cisco 7301 Gigabit Ethernet Port 0/1
T X
G B IC
ET HE RN ET
0/ 0
G IG AB IT ET
LI NK
HE RN ET 0/
1
RJ 45 EN
TX
G BI C
RX
LI NK
RJ 45 EN
TX
G BI C
RX
SE R IE S
2
SFP GBIC port 0/1
The SFP GBIC module is keyed so that it cannot be inserted incorrectly.
R X
1
G IG AB IT ET
HE RN ET 0/
2
LI NK AU X
CO NS O LE
TX
G BI C
RX
CO M PA C
FL AS H
2
Cisco 7301 Installation and Configuration Guide
Installing the SFP GBIC Module
SFP GBIC module
1-11