Cisco 7301 Installation And Configuration Manual page 81

Chapter 3 Starting and Configuring the Router
Gi0/1.200
Gi0/1.201
Gi0/1.202
Gi0/1.206
Gi0/1.2002 602
Gi0/1.2004 604
Using the show mpf interface GigabitEthernet 0/1 Command
The following example displays the interface information for GigabitEthernet 1/0, subinterface number
100. However, all GigabitEthernet interface and subinterface information are displayed because MPF
does not recognize the subinterface number, unless it is a VLAN number.
Router# show mpf interface Gigabit Ethernet 0/1.100
Name
Gi0/1
Gi0/1
Gi0/1.100
Gi0/1.101
Gi0/1.102
Gi0/1.105
Gi0/1.106
Gi0/1.107
Gi0/1.200
Gi0/1.201
Gi0/1.202
Gi0/1.206
Gi0/1.2002
Gi0/1.2004
Using the show mpf interface GigabitEthernet 01/100 Command
The following example displays the interface information for VLAN number 100 on GigabitEthernet 0/1
interface, including up state, receiving packet count, receiving bytes count, transmitting packet count,
transmitting bytes count, and receiving punts count.
Router# show mpf interface GigabitEthernet 0/1 100
Name
Gi0/1.100 100
IP Multi-Processor Forwarding is enabled
OL-5418-07
200 up
201 up RX punts
202 up
206 up
up RX punts
up
Index State
0 up
1 up
100 up
101 up
102 up
105 up
106 up
107 up
200 up
201 up
202 up
206 up
602 up
604 up
Index State
up
29
26114
Counter
RX packets
RX bytes
TX packets
TX bytes
RX punts
TX punts
RX packets
RX bytes
TX packets
TX bytes
RX punts
RX punts
RX punts
Counter Packets
RX total 963
RX punt 5
TX total 956
Cisco 7301 Installation and Configuration Guide
Enabling the Second Processor
Count
1004
158632
5004
790632
32996
86062
1004
158632
5004
790632
25
29
26142
Bytes
151050
475
150449
3-25